AC Replacement in Palm Beach Gardens: Country Club Standard

Palm Beach Gardens AC systems sit in country club homes where the standard is quiet and discreet. The condenser is supposed to be hidden behind a stucco screen wall, the new thermostat needs to integrate with the rest of the home, and the install needs to be invisible from the front yard. The 2010 install is at end of life and the 2026 replacement needs to be appreciably better and meaningfully quieter.

We do full AC and HVAC replacement across Palm Beach Gardens: the golf-and-tennis communities, the older Frenchman's Creek and Eastpointe neighborhoods, the Garden Oaks and Mirabella streets, and the newer Alton and Gardens of Woodberry builds. Quiet variable-speed inverter systems, smart communicating thermostats, hidden line sets, hurricane-rated condenser pads.

The system disappears and the bill comes down at the same time.

PBG housing and the typical AC scope

Most PBG country club homes are 3,000 to 6,000 square feet with two or three AC systems serving different zones (master suite, main living, guest wing). The 2010 replacement was typically a 14 to 16 SEER multi-stage unit. The 2026 install is typically a 17 to 20 SEER variable-speed inverter heat pump with smart communicating controls.

City of Palm Beach Gardens permits

Full system replacements in PBG pull through the City of Palm Beach Gardens building department under Palm Beach County. We pull, schedule rough-in and final inspections, and close the permit in your name.

Country club community ARC paperwork

PGA National, BallenIsles, Mirasol, Old Marsh, Frenchman's Reserve, Frenchman's Creek, and Eastpointe all have ARC paperwork for any exterior change, including condenser placement and screening. We submit the unit specs and the placement to the community management before install and quote any required screening with the project.

Variable-speed inverter as the default

For PBG installs we install variable-speed inverter heat pumps (Daikin Fit, Carrier Greenspeed, Trane XV20i, Bryant Evolution Extreme) as the default. The compressor modulates from 25 to 100 percent capacity, holds a tighter temperature and humidity setpoint, runs quieter, and uses less power than a single-stage or two-stage at the same SEER nameplate rating.

Multi-zone systems and matched equipment

A typical 5,000 square foot PBG home has two or three independent systems serving the master, the main living, and the guest wing. We size each system to its actual zone load with a separate Manual J calculation, install matched indoor and outdoor units, and verify the static pressure on each is in range.

Smart thermostats and home integration

Modern communicating thermostats integrate with Apple Home, Google, Alexa, and the brand-specific apps. We pair the thermostat to the home network during commissioning, configure dehumidification setpoints (typically 45 to 50 percent summer), and verify any third-party integrations.

Hidden line sets, condenser screening, hurricane-rated pads

We hide line sets inside the wall cavity where possible, finish wall penetrations cleanly, and place the condenser behind any existing screen wall or shrub planting. Where the HOA or ARC requires new screening, we quote and install it with the project. Condenser pads are hurricane-rated with manufacturer-approved tie-downs. Service Finance and Renew Financial financing is available for qualified homeowners.